Total 7 results found for the keyword of "eos section 27 5 qos configuration fm6000 platform switches"
...
TAP Aggregation qos Handling on TAP Ports
Before eos 4.20.5F, qos behavior was not enforced for TAP aggregation ports, meaning that qos
behavior for packets passing through the device was not ...
... Verification
Configuring Priority-Flow-Control (PFC)
Configuring PFC Watchdog
DCBX and Flow Control Commands
Introduction
eos implements Link Layer Discovery
Protocol (LLDP) and the Data ...
... Across VRF
The eos DHCP relay agent supports forwarding of DHCP requests to DHCP servers located in a different VRF to the DHCP client interface VRF. In order to enable VRF support for the DHCP relay ...
... mode as shown below.
(config)# management ssh
(config-mgmt-ssh)# ip access-group [vrf ] in
(config-mgmt-ssh)# ipv6 access-group [vrf ] in
In eos 4.19.0, all VRFs are required to use the same ...
...
Fabric qos -- – Trident II platform switches
eos is optimized to support qos configuration on the Fabric interfaces on 7250x and 7300 series switches. Configuring qos on the Fabric interfaces ...
... are assigned to Ethernet interfaces.
Note: PDP is available only in eos versions 4.19.0F and
above.
A policy map consists of classes. Each class contains an eponymous class map and traffic
resolution ...
... full10G Not Present
Et4/7 connected1 full10G Not Present
Et4/8 connected1 full10G Not Present
Et4/9 connected1 full10G Not Present
switch>
Referencing Multi-lane Ports
eos supports two types of ...