Total 10 results found for the keyword of "eos section 39 2 igmp protocols"
igmp and igmp Snooping igmp Snooping igmp Host Proxy Description Supported Features igmp protocols Configuring igmp Configuring igmp Snooping igmp Host Proxy igmp and igmp Snooping Commands ...
... timestamp Drop count Device ID Egress interface FCS type Reserved TAP Aggregation Extra MPLS Pop (4 to 6 Labels) Available starting with eos Release 4.23.1F extra MPLS pop for TAP Aggregation ...
VCS to EVPN Hitless Migration VCS to EVPN Hitless Migration enables support for migrating from only using VCS as the control plane to only using EVPN as a control plane in a hitless manner concerning ...
EVPN VXLAN Single-Gateway Centralized Routing In a traditional EVPN VXLAN centralized anycast gateway deployment, multiple L3 VTEPs serve the role of the centralized anycast gateway. For the hosts ...
... Beginning with eos Release 4.25.0F, MLDv2 snooping is supported on MLAG deployments. Limitations The extraneous “Switch” interface should be ignored in show mld snooping counters and show mld snooping counters ...
... interface vlan 8 switch(config-if-Vl8)# pim ipv4 sparse-mode switch(config-if-Vl8)# Enabling PIM IPv6 Sparse Mode By default, eos disables IPv6 PIM disabled on an interface. The pim ipv6 sparse-mode ...
... to filter routes. The RACL divergence optimizes hardware resource usage on each forwarding ASIC. eos installs ACLs only on the hardware components corresponding to the member interfaces of the SVIs with ...
... Configuration Procedures VLAN Configuration Commands VLAN Introduction Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
IPv6 eos supports Internet Protocol version 4 (IPv4) and Internet Protocol version 6 (IPv6) for routing packets across network boundaries. This section describes Arista’s implementation of IPv6 ...
... eXtended Packet Numbering (XPN) cipher suites.   MACsec Limitations The following are the limitations of MACsec: eos supports MACsec only on point-to-point links unless static SAK is ...