Total 9 results found for the keyword of "eos section 39 4 configuring igmp snooping"
igmp and igmp snooping
igmp snooping
igmp Host Proxy
Description
Supported Features
igmp Protocols
configuring igmp
configuring igmp snooping
igmp Host Proxy
igmp and igmp snooping
Commands ...
...
TAP Aggregation QoS Handling on TAP Ports
Before eos 4.20.5F, QoS behavior was not enforced for TAP aggregation ports, meaning that QoS
behavior for packets passing through the device was not ...
Multicast Architecture
IP multicast is the transmission of data packets to multiple hosts through a common IP address. Arista switches support multicast transmissions through igmp, igmp snooping, ...
Protocol Independent
Multicast
Protocol Independent Multicast
(PIM) distributes multicast data using routes gathered by other protocols.
Arista switches support two types of PIM: PIM Sparse Mode (PIM-SM) ...
... This feature is designed to be used for
flows that are configured by a custom agent using the eos SDK or eAPI
and age out (expire) after a specified time period.
For example, if you are using a custom
agent ...
... Configuration
Procedures
VLAN Configuration
Commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... is a layer 2 feature that is configured on LAN switches. The Arista eos switch supports Option-37 insertion that allows relay agents to provide remote-ID information in DHCP request packets. DHCP servers ...
... mode as shown below.
(config)# management ssh
(config-mgmt-ssh)# ip access-group [vrf ] in
(config-mgmt-ssh)# ipv6 access-group [vrf ] in
In eos 4.19.0, all VRFs are required to use the same ...
Event Monitor
The event monitor writes system
event records to local files for access by SQLite database commands.
Note:
Beginning with release eos-4.20.5F, event-monitor is not enabled by default. ...