Total 10 results found for the keyword of "eos section 39 6 igmp and igmp snooping commands"
igmp and igmp snooping
igmp and igmp snooping igmp snooping igmp Host Proxy Description Supported Features igmp Protocols Configuring igmp Configuring igmp snooping igmp Host Proxy igmp and igmp snooping Commands ...
Switch Administration Commands
...  This command replaces the EOS CLI prompt with an SQLite prompt.switch#event-monitor interact sqlite> This command exits SQLite and returns to the EOS CLI prompt.sqlite> .quit switch# event-monitor ...
Test Access Point (TAP) Aggregation
...  TAP Aggregation QoS Handling on TAP Ports Before eos 4.20.5F, QoS behavior was not enforced for TAP aggregation ports, meaning that QoS behavior for packets passing through the device was not ...
Multicast Architecture
Multicast Architecture IP multicast is the transmission of data packets to multiple hosts through a common IP address. Arista switches support multicast transmissions through igmp, igmp snooping, ...
Protocol Independent Multicast
Protocol Independent Multicast Protocol Independent Multicast (PIM) distributes multicast data using routes gathered by other protocols. Arista switches support two types of PIM: PIM Sparse Mode (PIM-SM) ...
DirectFlow
... This feature is designed to be used for flows that are configured by a custom agent using the eos SDK or eAPI and age out (expire) after a specified time period. For example, if you are using a custom agent ...
Virtual LANs (VLANs)
... Configuration Procedures VLAN Configuration Commands VLAN Introduction Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
IPv6
... is a layer 2 feature that is configured on LAN switches. The Arista eos switch supports Option-37 insertion that allows relay agents to provide remote-ID information in DHCP request packets. DHCP servers ...
ACLs and Route Maps
... mode as shown below. (config)# management ssh (config-mgmt-ssh)# ip access-group [vrf ] in (config-mgmt-ssh)# ipv6 access-group [vrf ] in In eos 4.19.0, all VRFs are required to use the same ...
Event Monitor
Event Monitor The event monitor writes system event records to local files for access by SQLite database commands. Note: Beginning with release eos-4.20.5F, event-monitor is not enabled by default. ...