Total 50 results found for the keyword of "eos section 5 2 configuration"
Sample configurations EVPN VXLAN IRB Sample configuration In the topology below, we are connecting a Layer 2 site with a Layer 3 site using Layer 3 EVPN (type-5 route). Right side leaves are MLAG ...
... is used for broadcast, multicast, and unknown unicast traffic. For a list of VXLAN feature support in a specific eos release, consult the appropriate release notes here:https://www.arista.com/en/support/software-download. ...
CVX Client configuration This section describes the CVX client configuration and commands that enable CVX services. Most commands for the configuration of the CVX client infrastructure are accessed ...
Layer 2 configuration This chapter contains the following sections: Spanning Tree Protocol Link Layer Discovery Protocol VLANs DCBX and Flow Control ..
Layer 3 configuration This chapter covers the following Layer 3 sections: IPv4 IPv6 ACLs and Route Maps VARP OpenFlow DirectFlow Decap Groups Nexthop Groups ..
Interface configuration This chapter describes Ethernet ports supported by Arista switches as well as channel groups, port channels, port channel interfaces, Link Aggregation Control Protocol (LACP), ...
Managing eos Extensions The most simple and efficient way to make the most of the extensibility on which eos is built is through the use of extensions. An extension is a pre-packaged optional feature ...
... file. Note: The eos boot secret command is the recommended method for adding or modifying the PASSWORD configuration line. Command Syntax PASSWORD = encrypted_string Parameters encrypted_string the ...
Initial configuration and Recovery This chapter describes initial configuration and recovery tasks. Subsequent chapters provide details about features introduced in this chapter. This chapter contains ...
... have not been saved since the last boot. boot-config The boot-config file is an ASCII file that Aboot uses to configure console communication settings, locate the eos flash image, and specify initial ...
... sent 0:12:27 ago show flow tracking sampled flow-table The show flow tracking sampled flow-table command displays information about the active flows maintained in the eos. Command Mode EXEC ...
sFlow This chapter describes Arista's implementation of sFlow, including configuration instructions and command descriptions. Topics covered by this chapter include: sFlow Conceptual Overview sFlow ...
... eos version. This chapter discusses enabling the SNMP agent on an Arista switch and controlling notification transmissions from the agent. Information on using SNMP management systems is available in ...
VM Tracer This chapter describes VM Tracer configuration and usage and contains these sections: VM Tracer Introduction VM Tracer Description VM Tracer configuration Procedures VM Tracer ...
MapReduce Tracer This section describes Arista’s implementation of MapReduce Tracer, including configuration instructions and command descriptions. Topics covered by this section include: MapReduce ...
Inter-VRF Local Route Leaking Inter-VRF local route leaking allows the leaking of routes from one VRF (the source VRF) to another VRF (the destination VRF) on the same router. Inter-VRF routes can ...
Configuring EVPN Configuring BGP-EVPN and VCS on CVX Configuring BGP-EVPN Configuring VNI Bundle A VNI-aware-bundle represents a MAC-VRF that contains Layer 2 route entries from all VXLAN Network ...
EVPN and VCS Commands Router BGP configuration Mode next-hop resolution disabled redistribute service vxlan route-target route-target export route-target import route-target route-map  ...
Multiprotocol Label Switching (MPLS) Tunneling protocols encapsulate packets of a different protocol as the payload of a larger frame for delivery within networks utilizing the encapsulating protocol. ...
Multiprotocol Label Switching (MPLS) Tunneling protocols encapsulate packets of a different protocol as the payload of a larger frame for delivery within networks utilizing the encapsulating protocol. ...