Total 50 results found for the keyword of "eos section 5 2 configuration"
EVPN and VCS Commands
Global configuration Mode
router
general
Router BGP configuration Mode
next-hop
resolution disabled
redistribute
service vxlan
route-target
route-target
export
route-target ...
...
Starting in Release eos 4.23.1, ingress on inner IP header matching
in MPLS packets is also supported on PBR ACLs. In order to enable this, the following must
be configured in a user-defined TCAM profile: ...
BGP/MPLS L3 VPN
Border Gateway Protocol/ Multiprotocol Label Switching (BGP/MPLS) L3 Virtual rivate Network (VPN)
allows a Service Provider (SP) or an Enterprise to provide the
service of interconnecting ...
RSVP-TE LSR
RSVP-TE applies the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE), that is, to distribute MPLS labels for steering traffic and reserving bandwidth.
The eos implementation ...
RSVP-TE LER
RSVP-TE, the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE), is used
to distribute MPLS labels for steering traffic and reserving bandwidth. The Label Edge
Router (LER) ...
LDP Pseudowire
LDP pseudowire provides support for emulating Ethernet connections over a
Multiprotocol Label Switching (MPLS) network, and controlled using the extension of the MPLS
Label Distribution ...
VXLAN Commands
VXLAN Global configuration
Commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
VXLAN Interface configuration
Commands
vxlan flood vtep
vxlan multicast-group ...
Ethernet VPN (EVPN)
This chapter describes Arista’s EVPN implementation. sections in this chapter
include:
EVPN Overview
EVPN Layer
3 Core Operations
Integrated Routing and Bridging
VPN MPLS
Transport ...
... ID, along with the extended
communities of tunnel type (MPLS), MPLS Label value and
route-target.
Note: You require Release eos 4.21.1F and later versions with Jericho/Jericho+
platforms.
EVPN VxLAN ...
Integrated Routing and Bridging
In traditional data center design, inter-subnet forwarding is provided by a centralized
router, where traffic traverses across the network to a centralized routing ...
... it is binding a label. Note: All connected interfaces are advertised
as bound. However, eos currently advertised labels for /32 addresses, and FEC filter
is configured to install only x.x.x.200/32
prefixes. ...
BGP PIC Edge for EVPN VXLAN Routes for Remote VTEP Failures
When a remote VTEP goes down, this would require action by the IGP and BGP to
recompute a new best path traffic destined to affected BGP ...
VXLAN DSCP Mapping
VXLAN DSCP Mapping allows selecting Differentiated Services Code Point
DSCPand Traffic Class TC values for packets
at VTEPs ( VXLAN Tunnel Endpoint) along VXLAN encapsulation and ...
EVPN VXLAN Single-Gateway Centralized Routing
In a traditional EVPN VXLAN centralized anycast gateway deployment, multiple L3 VTEPs
serve the role of the centralized anycast gateway. In order for ...
Inter-VRF Local Route Leaking
Inter-VRF local route leaking
allows the leaking of routes from one VRF (the source VRF) to another
VRF (the destination VRF) on the same router. Inter-VRF routes can ...
VCS to EVPN Hitless Migration
VCS to EVPN Hitless Migration enables support for migrating from only using VCS as the control plane to only using EVPN as a control plane in a hitless manner with respect ...
... offers an echo function. eos supports
asynchronous mode and the echo function.
Asynchronous Mode
Demand Mode
Asynchronous Mode
In asynchronous mode, BFD control packets are exchanged by neighboring ...
... is the protocol used to manage
the membership of hosts in multicast groups for IPv6.
RFC 3810 talks about MLDv2 functionality. MLDv2 is the IPv6 counterpart of IGMPv3. Beginning with eos Release 4.25.0F, ...
IGMP and IGMP Snooping
IGMP Snooping
IGMP Host Proxy
Description
Supported Features
IGMP Protocols
Configuring IGMP
Configuring IGMP Snooping
IGMP Host Proxy
IGMP and IGMP Snooping
Commands ...
Protocol Independent
Multicast
Protocol Independent Multicast
(PIM) distributes multicast data using routes gathered by other protocols.
Arista switches support two types of PIM: PIM Sparse Mode ...