Total 4 results found for the keyword of "wap c130 connect access point to the network"
connect C-130 to the network
the device can be connected to the network by connecting through a LAN cable or a POE+ injector. If you are using a PoE+ injector, make sure the data connection is plugged ...
Power on the C-130
the C-130 device can be powered on by plugging one end of the Ethernet cable into the PoE+ (802.3at) switch or injector and the other end into the Ethernet/PoE+ port on the C-130. ...
Install the C-130
This chapter contains the step wise procedure to install the C-130 device.
Zero-Configuration of C-130 as access point
Zero-configuration is supported under the following ...
C-130 Troubleshooting
the table below lists some of the troubleshooting guidelines for the access point (AP).
Problem
Solution
the AP did not receive a valid IP address via the ...