Back Panel Features and Indicators
This section displays the back panel of the DCA-CV-100 CloudVision Appliance.
DCA-CV-100 CloudVision Appliance (Back Panel View)
|Number||Indicator, Button, or Connector||Description|
|1||Serial Connector||Allows you to connect a serial device to the system.|
|2||Ethernet Connector 1||Integrated 10/100/1000 Mbps NIC connector.|
|3||vFlash Card Slot (optional)||Allows you to connect the vFlash card.|
|4||iDRAC Port (optional)||Dedicated management port on the iDRAC ports card.|
|5||PCIe Expansion Card Slots (2)||Allows you to connect a PCI Express expansion card.|
|6||Video Connector||Allows you to connect a VGA display to the system.|
|7||Ethernet Connector 2||Integrated 10/100/1000 Mbps NIC connector.|
|8||USB Connector||Allows you to connect USB devices to the system. The port is USB 2.0-compliant.|
|9||USB Connector||Allows you to connect USB devices to the system. The port is USB 3.0-compliant.|
|10||System Identification Button||The identification buttons on the front and back panels can be used to
locate a particular system within a rack. When one of these buttons is pressed,
the system status indicator on the back flashes until one of the buttons is
Press to toggle the system ID on and off. If the system stops responding during POST, press and hold the system ID button for more than five seconds to enter BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC setup) press and hold the button for more than 15 seconds.
|11||System Identification Connector||Connects the optional system status indicator assembly through the optional cable management arm.|
|12||Ethernet Connector 3||Integrated 10/100/1000 Mbps NIC connector.|
|13||Ethernet Connector 4||Integrated 10/100/1000 Mbps NIC connector.|
|14||Power Supply (PSU1 and PSU2)||Up to two 550 W redundant AC power supplies. (One supplied.)|