Using the C-200 with Power Adapter

Use a compatible power adaptor (Arista SKU: PWR-AP-W3 (12V 2A)) to power the C-200.

Warning: The C-200 is intended to be supplied with UL-listed PoE power source suitable for use at 40ºC, and whose output meets LPS requirements or PS2, with a rating of 48V DC 260mA minimum. If you are not using PoE, ensure that you use only an AC power adapter supported by the C-200 access point (AP). This product is intended to be supplied by a Listed Direct Plug-In Power Unit marked “Class 2”, Listed Power Adapter or DC power source marked “L.P.S.” (or “Limited Power Source”) and rated from 12V 2A (Arista SKU: PWR-AP-W3).

To power up the device with power adapter, perform the following steps:
  1. Plug the power cable into the DC power receptacle at the rear of the device.
  2. Plug the other end of the power cable into an 110V~240V 50/60 Hz AC power source.
  3. Wait until the device is ready. Refer to the LED status table.