Total 22 results found for the keyword of "eos section 13 6 mlag commands"
VXLAN commands
VXLAN Global Configuration
commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
VXLAN Interface Configuration
commands
vxlan flood vtep
vxlan multicast-group ...
... be enabled or disabled on the fly
without impacting regular packet forwarding functionality.
AVA Switch Sensor Extension
AVA switch sensor extends eos telemetry for network threat detection. The FlowWatcher
agent ...
Sample Configurations
EVPN VXLAN IRB Sample Configuration
In the topology below, we are connecting a Layer 2 site with a Layer 3 site using Layer 3
EVPN (type-5 route). Right side leaves are mlag ...
BGP PIC Edge for EVPN VXLAN Routes for Remote VTEP Failures
When a remote VTEP goes down, this would require action by the IGP and BGP to
recompute a new best path traffic destined to affected BGP ...
EVPN VXLAN Single-Gateway Centralized Routing
In a traditional EVPN VXLAN centralized anycast gateway deployment, multiple L3 VTEPs
serve the role of the centralized anycast gateway. In order for ...
... is the protocol used to manage
the membership of hosts in multicast groups for IPv6.
RFC 3810 talks about MLDv2 functionality. MLDv2 is the IPv6 counterpart of IGMPv3. Beginning with eos Release 4.25.0F, ...
IGMP and IGMP Snooping
IGMP Snooping
IGMP Host Proxy
Description
Supported Features
IGMP Protocols
Configuring IGMP
Configuring IGMP Snooping
IGMP Host Proxy
IGMP and IGMP Snooping
commands ...
Protocol Independent
Multicast
Protocol Independent Multicast
(PIM) distributes multicast data using routes gathered by other protocols.
Arista switches support two types of PIM: PIM Sparse Mode ...
VXLAN Description
These sections describe VXLAN architecture, the data objects that comprise a VXLAN network, and
process of bridging packets through a VXLAN network.
VXLAN Architecture
VXLAN Gateway ...
... identifier or
a single Customer Edge (CE) to the participating multiple Provider Edge
(PE). The default mode of operation is All-active. Introduced in the
eos 4.26.0F for VxLAN, singe-active is
another ...
... for OSPFv2 adjacencies with DR Other neighbors.
OSPFv2 Multiple Instances Support
eos Release 4.22.1F adds support for multiple OSPFv2 instances to
be configured in the default VRF. OSPFv2 Multiple ...
... area and interface levels.
Note: On the same area or interface, eos allows security configuration with either AH or ESP but not both. We can have one area or interface configured with AH and another ...
... and destination
addresses..
ACLs can also be made dynamic (not persisting in the eos), and the
payload keyword can be used to
turn an ACL into a User-Defined Field (UDF) alias for use in other ACLs. ...
VRRP and VARP
A virtual IP (VIP) address
is an IP address that does not directly connect to a specific interface.
Inbound packets sent to a Virtual IP address are redirected to a physical
network ...
Spanning Tree Protocol
Spanning Tree Protocols prevent
bridging loops in Layer 2 Ethernet networks. Arista switches support
Rapid Spanning Tree, Multiple Spanning Tree, and Rapid-Per VLAN Spanning
Tree ...
... Configuration
Procedures
VLAN Configuration
commands
VLAN Introduction
Arista switches support industry standard 802.1q VLANs. Arista eos provides tools to manage and extend VLANs throughout the ...
... VOQ0 are in WRR with a static credit ratio 2:3:6 (higher ratio
implies more credits).
The subinterface inherits the trust mode of the parent interface.
Before eos Release 4.24.2F, shaping is supported ...
... ensure disable-vrf configuration to take effect.
switch(config)# agent SandL3Unicast terminate
SandL3Unicast was terminated
Starting from the eos Release 4.26.0F, /32 prefix length optimization ...
... 32-bit
integer used in the candidate path selection
algorithm to select the “active” candidate path.
The default value for preference is
100.
Binding SID (BSID): an optional,
SID.Note: In eos, a BSID ...
... (also configured as a dynamic LAG) on the partner switch. The maximum number of ports per LAG varies by platform; numbers for each platform in the latest eos release are available here: https://www.arista.com/en/support/product-documentation/supported-features. ...