Total 29 results found for the keyword of "eos section 3 2 processing commands"
... this example, eos sends hello messages to all known neighbors every
10 seconds. If the switch does not receive
hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses
communication and the ...
VXLAN commands
VXLAN Global Configuration
commands
interface vxlan
ip address virtual
vxlan vni notation
dotted
VXLAN Interface Configuration
commands
vxlan flood vtep
vxlan multicast-group ...
Session Management commands
Global Configuration commands
commit timer
configure replace
configure session
management api eos-sdk-rpc
management api external-services
management api gnmi
management ...
... can be enabled or disabled on the
fly without impacting regular packet forwarding functionality.
NDR Switch Sensor Extension
NDR switch sensor extends eos telemetry for network threat detection. The ...
... clusters. This means the directly connected
TaskTracker nodes can belong to different clusters. eos supports a maximum of five
clusters per switch.
MapReduce Tracer Configuration
The MapReduce Tracer ...
... manager can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
Configuring RSVP-TE
The configuration of RSVP-TE requires the configuration of one or more of the following:
Configuring RSVP-TE LER
Configuring RSVP-TELSR
Configuring RSVP-TE P2MP LER ...
... a GRE tunnel, the payload of the outgoing GRE packet contains the payload of
the incoming source packet starting from the MPLS header. eos
strips L2 and outer L3 headers from the mirror copy. When the
MPLS ...
... router-mac ba:ed:43:3f:ca:8e
MLAG
This feature applies only to the scenario when two different MLAG VTEP pairs learn the
remote prefix.
Prior to 4.26.0F, eos supports this feature on the primary ...
... Beginning with eos Release 4.25.0F, MLDv2 snooping is supported on MLAG deployments.
Limitations
The extraneous “Switch” interface should be ignored in show mld
snooping counters and show mld snooping
counters ...
IGMP and IGMP Snooping
IGMP Snooping
IGMP Host Proxy
Description
Supported Features
IGMP Protocols
Configuring IGMP
Configuring IGMP Snooping
IGMP Host Proxy
IGMP and IGMP Snooping
commands ...
... interface vlan 8
switch(config-if-Vl8)# pim ipv4 sparse-mode
switch(config-if-Vl8)#
Enabling PIM IPv6 Sparse Mode
By default, eos disables IPv6 PIM disabled on an interface. The pim ipv6 sparse-mode ...
... OSPFv2 adjacencies with DR Other neighbors.
OSPFv2 Multiple Instances Support
eos Release 4.22.1F adds support for multiple OSPFv2 instances to
be configured in the default VRF. OSPFv2 Multiple Instances ...
... area
and interface levels.
Note: On the same area or interface, eos allows security configuration with either AH or ESP but not
both. We can have one area or interface configured with AH and
another ...
... in
section 2.1.1.2 of RFC8667.
The following enhancements are available by release:
eos Release 4.22.1F adds support for TI-LFA backup paths that protect IS-IS SR labeled traffic corresponding to a ...
... list, or profile, of resolution RIB domains (for example, either tunnel or IP domain). This allows eos to direct specific services over the specified RIB domains, overriding the default behavior. Further, ...
...
Maintenance Mode Configuration
Maintenance Mode commands
Overview
Using maintenance mode, you can perform several maintenance activities, such as:
eos image upgrade.
Initial configuration ...
... offers an echo function. eos supports
asynchronous mode and the echo function.
Asynchronous Mode
Demand Mode
Asynchronous Mode
In asynchronous mode, BFD control packets are exchanged by neighboring ...
... to filter routes.
The RACL divergence optimizes hardware resource usage on each forwarding ASIC. eos installs ACLs only on the hardware components corresponding to the member interfaces of the SVIs with ...