- Written by Kallol Mandal
- Posted on 3月 3, 2023
- Updated on 3月 7, 2023
- 5655 Views
In a VXLAN routing setup using VXLAN Controller Service (VCS), this feature will enable the following on a switch that is running as a VCS client.
- Written by Kallol Mandal
- Posted on 4月 25, 2022
- Updated on 9月 25, 2024
- 7865 Views
Overlay IPv6 routing over VXLAN tunnel using an anycast gateway (direct routing) has been previously supported using the “ipv6 virtual-router” configuration for both the data-plane and EVPN (or CVX) control-plane learning environments.
- Written by Kallol Mandal
- Posted on 11月 14, 2019
- Updated on 12月 22, 2020
- 11063 Views
Starting with EOS release 4.22.0F, the EVPN VXLAN L3 Gateway using EVPN IRB supports routing traffic from one IPV6
- Written by Kallol Mandal
- Posted on 1月 17, 2019
- Updated on 1月 23, 2019
- 8690 Views
In certain VXLAN deployments with either NSX/Logical Router or EVPN IRB, active nodes hosting a virtual IP address
- Written by Kallol Mandal
- Posted on 1月 17, 2019
- Updated on 10月 9, 2024
- 7582 Views
Selective ARP install is the selective programming of remote ARPs in hardware as received through EVPN Type 2 MAC-IP routes in an EVPN VXLAN/ MPLS Integrated Routing and Bridging (IRB) scenario. Instead of installing every MAC+IP binding received from EVPN into the hardware, the switch installs them only when there is routed traffic destined to the IP, thereby saving TCAM space on the switch. However, there is a tradeoff as there is an initial one-time latency to install the hardware TCAM entry on the first flow of routed traffic to the IP.