Total 4 results found for the keyword of "wap o105 connect the o 105 using poe"
connect the O-105 to the Network
To connect the access point (AP) to the network, perform the following steps:
Ensure that a DHCP server is available on the network to enable network configuration ...
Power On the O-105
An O-105 device can be powered on by plugging one end of the Ethernet cable into the 802.3at Power Over Ethernet+ (poe+) switch or injector and the other end into the Ethernet/poe ...
Bottom Panel of O-105
the bottom panel of the O-105 has LAN/poe connectors that enable you to connect the device to a wired LAN through a switch or a hub. the ports provide power for the device by ...
Access Point Overview
the O-105 is a dual radio 802.11ac wave 2 access point.
This chapter provides an overview of the O-105 and describes:
Side Panel of O-105
Bottom Panel of O-105
...