EOS 4.24.2F TOI

This feature adds the support for learning multiple equal cost routes for a destination in the RIP protocol. This

Configurable port qualifier sizing allows for dynamic resizing of the hardware TCAM feature qualifier for IPKGV

IPv6 Unicast Reverse Path Forwarding (uRPF) can help limit malicious IPv6  traffic on a network. uRPF works by

This feature adds the support for MD5 authentication in RIP. MD5 authentication adds the additional layer of

Media Access Control Security (MACsec) is an industry standard encryption mechanism that protects all traffic

This feature adds support for a selected set of configured interfaces to collect egress flow samples. Egress sFlow can be configured on ethernet and port-channel interfaces.

Topology Independent Fast Reroute, or TI-LFA, uses IS-IS SR to build loop-free alternate paths along the post-convergence path. These loop-free alternates provide fast convergence.

Access Control Lists (ACL) use packet classification to mark certain packets going through the packet processor pipeline and then take configured action against them. Rules are defined based on various fields of packets and usually TCAM is used to match packets to rules. For example, there can be a rule to match the packet source IP address against a list of IP addresses, and drop the packet if there is a match. This will be expressed in TCAM with multiple entries matching the list of IP addresses. Number of entries is reduced by masking off bits, if possible. TCAM is a limited resource, so with classifiers having a large number of rules and a big field list, TCAM runs out of resources.

BGP routing information often contains more than one path to the same destination network. The BGP best-path selection algorithm determines which of these paths should be considered as the best path to that network.

Two rate three color marker (TrTCM) meters an incoming packet stream and marks the packets based on two rates, PIR

Unidirectional links is a feature that configures an Ethernet interface transmit and receive paths to be

Prior to EOS 4.24.1F, per-destination steering into an SR Policy was only supported for IP unicast BGP routes in the default VRF. Support for additional AFI/SAFIs were added as follows: EOS 4.24.2F: L2 EVPN — EOS 4.27.2F: BGP Labeled Unicast

This document describes the support of VxLAN Bridging and Routing on the R3 series of DCS 7280, 7500 and 7800 Arista

The VxLAN VTEP counters feature allows the device to count VxLAN packets received and sent by the device on a per VTEP

The “vxlan bridging vtep to vtep” feature allows VXLAN encapsulated packets ingressed at an Arista switch from a

Some devices connected to Dot1x port in trunk phone mode won’t start authentication until it is awakened with a