Total 50 results found for the keyword of "eos section 11 6 ethernet configuration"
Sample configurations
EVPN VXLAN IRB Sample configuration
In the following topology, we are connecting a Layer 2 site with a Layer 3 site using Layer
3 EVPN (type-5 route). The right side leaves ...
... STP state. When an interface used as an ethernet segment does not have a forwarding
state, eos considers the interface to be inactive. For a VLAN-based service, the port must be in a forwarding state
on ...
ethernet VPN (EVPN)
This chapter describes the Arista EVPN implementation. sections in this chapter
include the following topics:
EVPN Overview
EVPN Layer
3 Core Operations
Integrated Routing and ...
Layer 2 configuration
This chapter contains the following sections:
Spanning Tree Protocol
Link Layer Discovery Protocol
Virtual LANs (VLANs)
DCBX and Flow Control
IP Address Locking
Layer 2 ...
... command for shutting down the Tx output path for unidirectional
mode.
1-second update of pre-FEC BER, OSNR, ESNR.
400GBASE-ZR transceiver with Open Forward Error Correction (O-FEC) (eos
release 4.25.2F.) ...
Interface configuration
This chapter describes ethernet ports supported by Arista switches as well as channel
groups, port channels, port channel interfaces, Link Aggregation Control Protocol
(LACP), ...
... as Signal-To-Noise Ratio, Residual Inter Symbol Interference, PAM4 Level Transition Parameters, and other parameters supported on optics interfaces.
Using the Performance Monitoring feature allows eos ...
VM Tracer
This chapter describes VM Tracer configuration and usage and contains these sections:
Introducing VM Tracer
VM Tracer Description
VM Tracer configuration Procedures
VM Tracer Commands ...
... manager can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This ...
...
sFlow exports packet samples and topology meta data to a centralized collector
application.
sFlow scales and operates on all switch ports simultaneously.
eos implements sFlow on all switches, without ...
... clusters. This means the directly connected
TaskTracker nodes can belong to different clusters. eos supports a maximum of five
clusters per switch.
MapReduce Tracer configuration
The MapReduce Tracer ...
... template interval 3400000
Hardware Flow Tracking with IPFIX Export
Hardware Flow Tracking uses match criteria to collect data from packets based on defined
flow profiles. eos sends the collected ...
Latency Analyzer (LANZ)
Arista Networks’ Latency Analyzer (LANZ) is a family of eos features that provide enhanced
visibility into network dynamics, particularly in areas related to the delay packets
experience ...
RSVP-TE LSR
RSVP-TE applies the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE) to distribute MPLS labels for steering traffic and reserving bandwidth.
The eos implementation supports ...
LDP Pseudowire
LDP pseudowire provides support for emulating ethernet connections over a
Multiprotocol Label Switching (MPLS) network, and controlled using the extension of the MPLS
Label Distribution ...
...
Examples
In this example, eos sends hello messages to all known neighbors every
10 seconds. If the switch does not receive
hello responsesfrom a neighbor for 4*10=40 seconds, the switch loses
communication ...
... timestamp
Drop count
Device ID
Egress
interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP
Aggregation ...
... a GRE tunnel, the payload of the outgoing GRE packet contains the payload of
the incoming source packet starting from the MPLS header. eos
strips L2 and outer L3 headers from the mirror copy. When the
MPLS ...
EVPN and VCS Commands
Global configuration Mode
router
general
Router BGP configuration Mode
next-hop
resolution disabled
redistribute
service vxlan
route-target
route-target
export
route-target ...
...
eos adds a new parameter in the output, evpn prefix detail to display the
ATTR_SET, code 128 attributes.
switch#show bgp evpn
BGP routing table information for VRF default
Router identifier 10.11.0.1, ...