Total 48 results found for the keyword of "eos section 26 3 configuring ipv6"
... snooping is a Layer 2 feature that is
configured on LAN switches. The Arista eos switch supports Option-37 insertion that
allows relay agents to provide remote-id information in DHCP request packets. DHCP
servers ...
... displays
information about the active flows maintained in the eos.
Command Mode
EXEC
Command Syntax
show flow tracking sampled flow-table [
detail | dst-ip |
dst-port | group |
interface | protocol ...
... available for other eos applications.
With hardware acceleration, all sFlow processing is done in hardware
using specialized chips, called accelerators. These accelerators
process sampled packets and ...
... can request or change. The agent gathers data from the MIB and responds to requests for information. For a list of supported MIBs, refer to the release notes for the specific eos version.
This chapter ...
... be enabled or disabled on the fly
without impacting regular packet forwarding functionality.
AVA Switch Sensor Extension
AVA switch sensor extends eos telemetry for network threat detection. The FlowWatcher
agent ...
BGP/MPLS L3 VPN
Border Gateway Protocol/ Multiprotocol Label Switching (BGP/MPLS) L3 Virtual rivate Network (VPN)
allows a Service Provider (SP) or an Enterprise to provide the
service of interconnecting ...
RSVP-TE LSR
RSVP-TE applies the Resource Reservation Protocol (RSVP) for Traffic Engineering (TE), that is, to distribute MPLS labels for steering traffic and reserving bandwidth.
The eos implementation ...
...
show traffic-engineering database
Use the show traffic-engineering database to display the topology used for CSPF computations. Starting from eos Release 4.23.1F, the SRLG group details of a neighbor ...
...
Drop count
Device ID
Egress interface
FCS type
Reserved
TAP Aggregation Extra MPLS Pop (4 to 6 Labels)
Available starting with eos Release 4.23.1F extra MPLS pop for TAP Aggregation ...
Inter-VRF Local Route Leaking
Inter-VRF local route leaking
allows the leaking of routes from one VRF (the source VRF) to another
VRF (the destination VRF) on the same router. Inter-VRF routes can ...
Sample Configurations
EVPN VXLAN IRB Sample Configuration
In the topology below, we are connecting a Layer 2 site with a Layer 3 site using Layer 3
EVPN (type-5 route). Right side leaves are MLAG ...
...
Starting in Release eos 4.23.1, ingress on inner IP header matching
in MPLS packets is also supported on PBR ACLs. In order to enable this, the following must
be configured in a user-defined TCAM profile: ...
... it is binding a label. Note: All connected interfaces are advertised
as bound. However, eos currently advertised labels for /32 addresses, and FEC filter
is configured to install only x.x.x.200/32
prefixes. ...
BGP PIC Edge for EVPN VXLAN Routes for Remote VTEP Failures
When a remote VTEP goes down, this would require action by the IGP and BGP to
recompute a new best path traffic destined to affected BGP ...
... is the protocol used to manage
the membership of hosts in multicast groups for ipv6.
RFC 3810 talks about MLDv2 functionality. MLDv2 is the ipv6 counterpart of IGMPv3. Beginning with eos Release 4.25.0F, ...
Protocol Independent
Multicast
Protocol Independent Multicast
(PIM) distributes multicast data using routes gathered by other protocols.
Arista switches support two types of PIM: PIM Sparse Mode ...
... in the
eos 4.26.0F for VXLAN, singe-active is
another mode of operation in which only one PE per VLAN accepts traffic for
that ethernet segment.
Single-active multihoming is useful for:
Manually controlled ...
... for OSPFv2 adjacencies with DR Other neighbors.
OSPFv2 Multiple Instances Support
eos Release 4.22.1F adds support for multiple OSPFv2 instances to
be configured in the default VRF. OSPFv2 Multiple ...
... area and interface levels.
Note: On the same area or interface, eos allows security configuration with either AH or ESP but not both. We can have one area or interface configured with AH and another ...
...
Note: Unlike node segments, anycast segments do not have the ‘N’ flag set described in section 2.1.1.2 of RFC8667.
The following enhancements are available by release:
eos Release 4.22.1F adds support ...