EOS 4.24.0F TOI

Support for negotiating and receiving IPv6 unicast and IPv6 labeled unicast (6PE) updates from a BGP peer.

This article describes the support for specifying User Defined Fields (UDF) in Sub interface ACLs including IPv4 and

Subinterfaces divide a single ethernet or port channel interface into multiple logical L2 or L3 interfaces based on the 802.1q or 802.1ad tags of incoming traffic. Subinterfaces are commonly used in the L2/L3 boundary device, but they can also be used to isolate traffic with 802.1q tags between L3 peers by assigning subinterfaces to different VRFs or different L2 bridging domains.

In the ribd routing protocol model, the “maximum paths … ecmp …” command allows restricting the number of BGP

TAP Aggregation support for the DCS 7280R3 and DCS 7500R3 series is documented below, including the release in which a

BGP routing information often contains more than one path to the same destination network. The BGP best-path selection algorithm determines which of these paths should be considered as the best path to that network.

TCB provides a mechanism to capture information around a MMU(Memory management unit) drop event.

Two rate three color marker (TrTCM) meters an incoming packet stream and marks the packets based on two rates, PIR