- Written by Mihyar Baroudi
- Posted on December 8, 2015
- Updated on September 17, 2018
- 6210 Views
With this feature, user can fetch various internal hardware drops info from each switch and isolate the switch or
- Written by Mihyar Baroudi
- Posted on December 8, 2015
- Updated on February 7, 2022
- 4761 Views
DCS 7280E. Arad QOS MAP:. This command assigns the DSCP rewrite value of 37 to traffic classes 2, 4, and 6.
- Written by Pandurangan R S
- Posted on June 29, 2016
- Updated on September 8, 2021
- 5021 Views
Dual Tag VLAN mapping feature defines mapping between (outer VID and inner VID of double tagged packet) and bridging
- Written by James Pang
- Posted on May 1, 2015
- Updated on June 28, 2021
- 6563 Views
Starting with EOS4.15.0F, dynamic and symmetric LAG hashing policies are supported on the 7500E platform. Dynamic
- Written by Mihyar Baroudi
- Posted on December 8, 2015
- Updated on April 23, 2021
- 4687 Views
Dynamic resizing of nexthop groups, as the name suggests, is a feature that enables a nexthop group to dynamically
- Written by Ziqian XU
- Posted on November 22, 2017
- Updated on July 21, 2023
- 4503 Views
This feature allows eAPI to run in multiple non default VRFs on the same physical router. In this way, users can
- Written by Lavanya Conjeevaram
- Posted on June 29, 2016
- Updated on April 22, 2024
- 7907 Views
ECMP Hash visibility CLI determines the output interface for an ECMP set based on the flow parameters supplied by the user. Ingress interface, source IP address, destination IP address and IP protocol are the required parameters. L4 source and destination ports and VLAN identifier are optional, but should be specified if the packet has them.
- Written by Mihyar Baroudi
- Posted on December 8, 2015
- Updated on December 21, 2015
- 5132 Views
This feature provides the capability to count the number of packets hitting rules associated to egress ACLs applied
- Written by Sriharsha J
- Posted on May 1, 2015
- Updated on February 5, 2022
- 4690 Views
Egress ACL deny logging on Arista DCS 7280E, DCS 7500 and DCS 7500E series switches allows the logging of the
- Written by Mouli Baskaran
- Posted on May 1, 2015
- Updated on March 19, 2016
- 4422 Views
IPv4/IPv6 over MPLS packets are now eligible for ACLs at egress stage by default. The feature is applicable only to
- Written by Anupama Srivastava
- Posted on September 30, 2015
- Updated on February 8, 2022
- 4506 Views
This feature optimizes the utilization of hardware resources by sharing tcam entries for a group of SVIs on which an
- Written by Dhruba Jyoti Pokhrel
- Posted on July 7, 2023
- Updated on July 7, 2023
- 2542 Views
RadSec or RADIUS over TLS is a protocol for secure communication between a client and the RADIUS server. RadSec uses TCP and TLS protocols to form a secure tunnel between the client and the server.
- Written by Akshay Gattani
- Posted on February 8, 2017
- Updated on February 9, 2017
- 4587 Views
The BGP implementation now provides the ability to display the age of paths received for a given prefix using the
- Written by Kenneth Cheung
- Posted on November 22, 2017
- Updated on July 21, 2023
- 6133 Views
EOS 4.20.1F introduces expanded VRRP, VARP and MLAG Peer Gateway virtual MAC capabilities on the 7500R, 7280R,
- Written by Mihyar Baroudi
- Posted on December 8, 2015
- Updated on February 7, 2022
- 4599 Views
IP in IP decapsulation was first introduced for the supported platforms(below) in EOS version 4.15.0F (IP in IP
- Written by Lavanya Conjeevaram
- Posted on April 1, 2015
- Updated on August 2, 2022
- 725 Views
DANZ provides a set of features and tools to enhance instrumentation and network/ application performance monitoring with the following key functional areas.
- Written by Mihyar Baroudi
- Posted on September 11, 2017
- Updated on October 31, 2019
- 5744 Views
The EOS Event Manager feature provides the ability to specify a condition and an action to be carried out when that
- Written by Mihyar Baroudi
- Posted on September 11, 2017
- Updated on May 7, 2024
- 6659 Views
The EOS Event Manager feature, introduced in 4.17.0F, provides the ability to specify a condition and an action
- Written by Mihyar Baroudi
- Posted on September 11, 2017
- Updated on February 8, 2022
- 6827 Views
The EOS Event Manager feature provides the ability to specify a condition and an action to be carried out when that
- Written by Manuel Lai
- Posted on June 9, 2017
- Updated on August 2, 2022
- 2657 Views
The ability to monitor and react to Syslog messages provides a powerful and flexible tool that can be used to apply self
- Written by Julie Powell
- Posted on April 3, 2024
- Updated on April 3, 2024
- 711 Views
Event Rollup allows you to manage the volume of identical events and can be used to flag when an event is recurring. Event Rollup groups together events that are identical except for their timestamps. It does so in two ways: dynamically via the Event List and according to a 24-hour window via the detailed event view. It can be enabled or disabled at will, using the Roll Up toggle.
- Written by Alton Lo
- Posted on July 13, 2018
- Updated on February 7, 2022
- 8359 Views
EVPN IRB interface supports both L2 switching and L3 Vxlan Routing on the same TOR switch. In a typical EVPN IRB
- Written by Lavanya Conjeevaram
- Posted on March 31, 2017
- Updated on November 29, 2023
- 10189 Views
Ethernet VPN (EVPN) is an extension of the BGP protocol introducing a new address family: L2VPN (address family
- Written by Lavanya Conjeevaram
- Posted on December 22, 2017
- Updated on April 10, 2024
- 6787 Views
In the traditional data center design, inter-subnet forwarding is provided by a centralized router, where traffic traverses across the network to a centralized routing node and back again to its final destination. In a large multi-tenant data center environment this operational model can lead to inefficient use of bandwidth and sub-optimal forwarding.
- Written by Xuan Qi
- Posted on March 13, 2020
- Updated on March 13, 2020
- 9023 Views
In EOS 4.22.0F, EVPN VXLAN all active multi homing L2 support is available. A customer edge (CE) device can connect to
- Written by Deva Pandian
- Posted on February 8, 2017
- Updated on February 5, 2022
- 5097 Views
This enhancement is to display the number of packets that were ECN (Explicit Congestion Notification) marked by the
- Written by Venkatesh Janakiraman
- Posted on April 10, 2015
- Updated on February 5, 2022
- 4532 Views
Starting EOS 4.15.0F, EOS can monitor (for long durations) low error rate errors on all fabric links. It
- Written by Anoop Dawani
- Posted on September 30, 2015
- Updated on September 30, 2015
- 4736 Views
The 7250X and 7300 series use an optimized internal CLOS design with multiple port ASICs interconnected via Fabric
- Written by Muhammad Yousuf
- Posted on April 18, 2015
- Updated on February 5, 2022
- 4940 Views
The 7280E and 7500E series are Virtual Output Queues (VOQs) based multi chip systems where there is a VOQ for all the
- Written by Prasanth Sasidharan
- Posted on September 30, 2015
- Updated on February 8, 2022
- 4607 Views
Fallback PBR policy enables an alternate policy to be active when PBR policy attached to an interface is being
- Written by Bobby Dhillon
- Posted on April 5, 2024
- Updated on April 5, 2024
- 469 Views
FIPS is a US federal standard for computer systems and data security that mandates only compliant cryptographic algorithms and their implementations be used in a product’s cryptographic operations. A product is considered FIPS compliant if it uses verified crypto modules that have been certified by a laboratory approved by the National Institute of Standards and Technology (NIST). CloudVision has completed the FIPS certification process to allow users with both single-node and multi-node clusters to operate in FIPS mode. Intra-node communication is not yet certified and will follow in Phase 2.
- Written by Lavanya Conjeevaram
- Posted on June 6, 2017
- Updated on December 22, 2017
- 5805 Views
MPLSoGRE Filtered Mirroring is a specialized version of Mirroring to GRE Tunnel and Filtered Mirroring in which
- Written by Prachi Modi
- Posted on January 17, 2024
- Updated on January 17, 2024
- 1309 Views
With the 16.0 release, CloudVision Cognitive Unified Edge (CV-CUE) introduces the following enhancements to Floor Plans:
- Written by Mihyar Baroudi
- Posted on December 8, 2015
- Updated on December 21, 2015
- 4456 Views
This feature enables detection of abnormal system flows (total in vs. out packet counters) by showing packet loss
- Written by Dhruba Jyoti Pokhrel
- Posted on April 1, 2024
- Updated on April 1, 2024
- 587 Views
This feature lets you freeze the channel and transmit power in the Auto mode to operate a specific radio at a specific channel number and transmit power. To switch to other channels, unfreeze the settings and select a custom channel and power, or enable the Auto mode to select the optimum channel and transmit power. Freeze and unfreeze Auto Channel Selection (ACS) and Transmit Power Control (TPC) configurations are configured for each radio. You can select multiple radios and freeze the ACS and TPC settings.
- Written by Syed Rahi
- Posted on September 30, 2015
- Updated on February 7, 2022
- 4426 Views
When a user configures IPv6 ACLs, by default, the system automatically includes two additional rules : a default
- Written by Nathan Wolfe
- Posted on June 29, 2016
- Updated on June 29, 2016
- 5773 Views
Users can now define a global LAG hashing profile. The global LAG hashing profile will be applied to all linecards
- Written by Qin Zhang
- Posted on September 30, 2015
- Updated on July 21, 2023
- 4586 Views
By default, inner IP header of a GRE packet is used for LAG hashing. With this feature, LAGs can hash GRE traffic
- Written by Pedro Coutinho
- Posted on August 25, 2016
- Updated on June 11, 2019
- 6999 Views
This feature involves the use of packet’s Time to Live (TTL) (IPv4) or Hop Limit (IPv6) attributes to protect
- Written by Ramakrishnan G
- Posted on February 8, 2017
- Updated on September 7, 2020
- 5123 Views
In ingress/egress and fabric/egress replication mode, on DCS 7280E, DCS 7280R, DCS 7500E and DCS 7500R, Broadcast,
- Written by Vincent Lam
- Posted on May 1, 2015
- Updated on May 1, 2015
- 4492 Views
The Hardware Switch Controller (HSC) provides an integration point between the SDN controllers (NSX or Nuage) and
- Written by Anoop Dawani
- Posted on September 30, 2015
- Updated on December 22, 2017
- 5481 Views
Hardware Table Capacity Monitoring is a new feature to keep track of the capacity and utilization of various hardware
- Written by Zhuohui Tan
- Posted on December 22, 2017
- Updated on October 8, 2018
- 5867 Views
Hierarchical Forwarding Equivalence Class (HFEC) changes a FEC from a single flat level to a multi level FEC
- Written by Aditi Vaidya
- Posted on August 23, 2019
- Updated on August 23, 2019
- 5776 Views
Keeping Wi Fi Access Point (AP) firmware up to date allows network administrators to take advantage of the latest
- Written by Prachi Modi
- Posted on February 20, 2023
- Updated on February 20, 2023
- 2860 Views
Hotspot 2.0 is a standard for public-access Wi-Fi that enables seamless roaming among Wi-Fi networks and between Wi-Fi and cellular networks. With Hotspot 2.0, Passpoint-certified mobile devices such as laptops and smartphones can automatically discover and connect to Wi-Fi networks without the need of signing in manually. It is based on IEEE 802.11u standard for Interworking with External Networks.
- Written by Prachi Modi
- Posted on July 7, 2023
- Updated on July 7, 2023
- 2429 Views
With the 15.0 release, CloudVision Cognitive Unified Edge(CV-CUE) provides you the ability to list down Vulnerable SSIDs and Hotspot SSIDs. CV-CUE takes action on the listed SSIDs according to the applied WIPS policy.
- Written by Madhu Sudan
- Posted on March 31, 2017
- Updated on July 13, 2017
- 4920 Views
External controllers can communicate with HSC (Hardware Switch Controller) running on CVX/EOS using the OVSDB
- Written by Avininder Grewal
- Posted on September 30, 2015
- Updated on September 30, 2015
- 4702 Views
Arista switches enable high precision time distribution directly in the data path using IEEE1588 Precision Time
- Written by Shyam Kota
- Posted on February 8, 2017
- Updated on July 6, 2020
- 4590 Views
IGMP Snooping Proxy feature is an optimization over IGMP snooping. When IGMP Snooping Proxy is enabled, the switch
- Written by Dhruba Jyoti Pokhrel
- Posted on July 7, 2023
- Updated on July 7, 2023
- 2500 Views
You can import Ekahau floor plans to CloudVision Cognitive Unified Edge (CV-CUE) and then manage the access points (AP) from CV-CUE. Once you import the floor plan to CV-CUE, you can map the AP to CV-CUE and start managing the AP.